Drywall

Drywall Repair After a Burst Pipe or Leak

By [OWNER NAME]·January 22, 2026·Last updated January 22, 2026

First, stop the water

Before anything else, stop the water at the source or the main shut-off. If the leak is from a plumbing system change that failed, you'll likely need a licensed plumber to fix the source before any drywall repair makes sense.

Once the water is stopped and the source is fixed, you can turn to the drywall.

Document it for insurance

Take photos and video of the damage, the source, and anything that was affected — before you start cutting. Note the date. Your insurer will want a clear record, and it protects you if the scope grows.

Dry it out first

Drywall that's been wet needs to dry completely before repair. Wet drywall loses strength, and hidden moisture behind it leads to mould. Use fans and dehumidifiers, and check that the cavity behind is dry, not just the face.

If a section is soft, bulging, or crumbles when pressed, it's done — it needs to come out, not be patched over.

Test before you cut or sand

Homes built before 1990 may contain asbestos in joint compound and textured ceilings. Before cutting or sanding, test — especially on textured ceilings, which are a common asbestos source.

Health Canada says homes built before 1960 probably have lead paint. If you're sanding old paint or it's chipping, take lead precautions.

If a test comes back positive for asbestos, the repair becomes a specialist job, not a handyman one. Stop and bring in the right pro.

Seal vs replace

A small, surface-only wet spot that dried quickly and is still firm can often be sealed, primed and painted. A section that was saturated, is soft, or shows the back of the drywall damaged needs to be cut out and replaced.

Replacement means cutting a clean square around the damage, installing backing, fitting a new piece, taping and mudding the seams, sanding, priming and painting to match.

The repair steps

  • Cut a clean, square opening around the damage.
  • Install wood backing behind the cut edges if there's no stud to screw to.
  • Fit a new drywall piece and screw it to the studs or backing.
  • Tape and mud the seams in coats, letting each dry.
  • Sand smooth, prime, and paint to match.
  • Document the finished repair for your records.

Frequently asked questions

Can I just patch over wet drywall?

No. Drywall has to be completely dry first, and any section that's soft, bulging or crumbling needs to come out, not be patched over. Hidden moisture leads to mould.

Do I need to test for asbestos before repairing?

If your home was built before 1990, yes — especially on textured ceilings and joint compound. If a test is positive, the repair becomes a specialist job. Health Canada also notes homes built before 1960 probably have lead paint.

Should I document the damage for insurance?

Yes. Take photos and video of the damage and the source before you cut anything, and note the date. Your insurer will want a clear record.

Do you repair drywall after leaks?

Yes — once the source is fixed and the area is dry. I'll check for soft spots, recommend asbestos testing for pre-1990 homes, and either repair in place or cut and replace the damaged section.

Need a hand with this? Get a free quote

Tell us what you need done — we'll get back to you with a clear quote.

CallGet a free quote